New door entry product that offers security, comfort and special purpose access to all users. Lock and be used with a key, swipe card and radio remote control. All three levels of entry are designed with maximum security in mind. Three keys come with the product. These keys are specially made so no duplication can be made. The swipe card is the size of a credit card. It has 128 bit encryption which is at the maximum level of security. The radio frequency remote control can work up to 50 meters in open space and around 20 meters in closed space. It does frequency hoping as would any car remote control. Operates on

Description

Electro- mechanical device, Card Sensor Radio Frequency, Electrical, opens very quickly, Uses rechargeable Li battery, Network compatible, Can be placed into an unlocked position, Remote control RF, Weather resistant, Metal Housing

Electric Parameter

Input Voltage: DC12V, Input Current: 1000mA, Dynamic Current: 800mA, Static Current: < 50mA, Power: 10W

1.According to the door opening direction (open on the left side/open on the right side), choose a circle center on the door which is 60mm away from the door edge. 2. Dig a lock hole which the diameter is 29mm on the center of the circle, and then make two sockets for the support panel of the lock head and lock tongue (inlay them to the door edge and make them at the same level.) 3. Put the lock head into the loop and insert it to the door. 4. Assemble the support panel and screw it. If the door panel is too thin, you can add a wooden block or assemble it with a cut screw. 5. Before you fix the lock with the screws, you should try the key at first. If you can open the door with the key freely, you can screw and fix the lock 6. Check whether the door-shutter can deal with the weight of the door. If you find too much noise or you can’t lock the door, you can use NO.12 spanner or pliers to screw the hexagon nut and adjust the load spring until you get the balance of the elasticity when you open or shut the door. 7. Assemble the shell to the doorframe and balance it with the width and height of the lock to make the bevel tongue and square tongue adjustable in the shell hole. Then, open the support panel socket in this position (inlay them to the door edge and make them at the same level) and screw it tight. 8. Get the signal line of the inductive Card Reader & Writer and insert it to the hole of the lock where the line goes out. 9. When the door is open to the outward direction, you should change the direction of the bevel tongue. The bevel tongue should be used after being installed in the opposite direction. a. Twist off the cover screw and take out the cover. b. Pull out the bolt. c. Take out the stopper loop. d. Take out the elastic loop. e. Take out the bevel tongue and rotate it for 180° f. Then assemble the parts mentioned above in the opposite direction.

The outside wiring of the electronic lock can be connected to the junction board of the lock body.

Red line ―――― connect to the anode of the DC12V

Black line ―――― connect to the cathode of the DC12V

Yellow line ―――― connect to the A of the 485 communication line

Green line ―――― connect to the B of the 485 communication line

Brown line ―――― connect to the anode of the extern lock-opening signals

Write line ―――― connect to the cathode of the extern lock-opening

signals

The two white-head lines are the motor lines which connect to the motor, The two black-head lines are the batter-line which connect to the lithium batteries. The 5-core soft line plug connects to the card-reading loop of the lock head. Connect the power line, then make the card approach the card reader. When hearing a sound “DI-”, it means all the lines are connected correctly.